Toro Workman HD Series Service Manual page 137

8. Install PTO intermediate shaft sub−assembly:
A. If removed during disassembly, insert bearing
into PTO housing.
B. Put gear on mating gear.
C. Move gear until bores of gear and bearing line up.
D. Insert intermediate shaft sub−assembly. Apply
grease to intermediate shaft to aid assembly.
9. Insert PTO shaft assembly into bearing housing of
PTO housing.
Workman HD Series
2
1. Intermediate shaft
sub−assembly
1. PTO shaft assembly
Page 6 − 67
3
Figure 140
3. Bearing
1
Figure 141
2. Gear
1
Figure 142
Drive Train