Toro Workman HD Series Service Manual page 291

Removal (Fig. 4)
1. Park vehicle on a level surface, shut engine off, re-
move key from ignition switch and apply parking brake.
2. Remove cap screw and flat washer that secure the
driveshaft yokes to differential input shaft and transaxle
output shaft.
WARNING
Support driveshaft to prevent it from dropping
and causing personal injury when removing.
3. Support driveshaft to prevent it from falling.
4. Slide driveshaft yokes from the differential input shaft
and the transaxle output shaft.
5. Lower rear of driveshaft and remove shaft from ve-
hicle.
Installation (Fig. 4)
1. Apply antiseize lubricant to differential input shaft
and transaxle output shaft.
2. Position driveshaft to vehicle frame, differential as-
sembly and transaxle.
3. Slide driveshaft yokes onto differential input shaft
and transaxle output shaft
4. Secure driveshaft yokes with cap screw and flat
washer.
5. Lubricate differential driveshaft grease fittings.
Workman HDX/HDX−D
1. Driveshaft flange yoke
1
1. Driveshaft slip yoke
Page 10 − 9
1
2
Figure 5
2. Differential assembly
2
Figure 6
2. Transaxle shaft
Front Wheel Drive (4WD)