Toro Workman HD Series Service Manual page 104

30.Disassemble differential fork shaft assembly:
A. Remove O−ring from fork shaft.
B. Remove snap ring, washer and spring.
C. Remove fork.
D. Remove lock pin if necessary.
31.Disassemble L.H. axle shaft:
A. Remove O−ring from differential carrier.
B. Remove snap ring.
C. Remove L.H. axle shaft assembly.
D. Remove snap ring and washer.
E. Use a bearing puller to remove bearing from axle
shaft.
F. Remove oil seal from differential carrier.
32.Disassemble R.H. axle shaft:
G. Remove R.H. axle shaft assembly from seal cov-
er.
H. Remove snap ring and washer from axle shaft.
I. Use a bearing puller to remove bearing.
J. Remove washer and oil seal from seal cover.
Drive Train
6
1. O−ring
2. Snap ring
3. Washer
4. Spring
4 2
5
1. O−ring
2. Snap ring
3. L.H. axle shaft assembly
4. Snap ring
5. Washer
6. Bearing
7. Oil seal
8. Differential carrier
Page 6 − 34
LOCK PIN
ARM
5 4 3 2 1 7
Figure 53
5. Fork
6. Lock pin
7. Fork shaft
1 8 3
L.H. SHAFT
7
6
11 14 9
R.H. SHAFT
10 12
15 13
Figure 54
9. R.H. axle shaft assembly
10. Snap ring
11. Washer
12. Bearing
13. Oil seal
14. Washer
15. Seal cover
Workman HD Series