Toro Workman HD Series Service Manual page 136

7. Install PTO input shaft sub−assembly:
A. Insert shifter block onto pin of shift arm. Apply
moly disulfide grease onto both sides of block before
installing.
B. Put shift collar of PTO input shaft sub−assembly
on the shifter block.
C. Install gear with bushing and thrust washer onto
input shaft after sliding the assembly toward PTO
shaft. Apply moly disulfide grease to bushing of gear
and thrust washer before installing.
D. Slide bearings onto input shaft.
E. Install retaining rings.
Drive Train
1. Retaining ring
2. Retaining ring
3. Input shaft assembly
4. Bearing
5. Bearing
3
4
3. Input shaft assembly
4. Bearing
5. Bearing
6. Thrust washer
Page 6 − 66
Figure 136
6. Thrust washer
7. Gear
8. Shift arm
9. Shifter block
Figure 137
6. Thrust washer
7. Gear
3
Figure 138
3. Input shaft assembly
7
6
Figure 139
7. Gear
Workman HD Series
MOLY
DISULFATE
GREASE
7
6
5