Rear Pto Switch (Optional Kit) - Toro Workman HD Series Service Manual

Rear PTO Switch (Optional Kit)

On vehicles equipped with the optional rear PTO kit, the
rear PTO switch is located in the rear PTO housing
mounted on the top of the transaxle. The Rear PTO
1
switch is normally closed and opens when the PTO is en-
gaged.
Testing
1. Park machine on a level surface, raise bed, stop en-
gine, apply parking brake and remove key from ignition
switch.
2. Install bed support on bed lift cylinder to prevent bed
from lowering.
Figure 46
3. Locate rear PTO switch and disconnect the wire har-
1. Rear PTO switch
ness connector from the switch.
4. Use a multimeter (ohms setting) to test for continuity
across the two (2) switch terminals. With the engine off
and the PTO lever in the OFF position, there should be
continuity (zero ohms). Move PTO lever to ON and there
should not be continuity (infinite ohms).
5. If necessary, replace switch.
6. When switch testing is complete, connect wire har-
ness connector to switch.
7. Remove bed support from lift cylinder and lower bed.
Workman HD Series Page 8 − 31 Electrical System