Toro Workman HD Series Service Manual page 128

8. Remove PTO input shaft from PTO housing:
A. Shift PTO to "ON" position.
B. Remove retaining rings from PTO housing.
C. Slide input shaft assembly toward PTO shaft.
D. Remove bearing (item 4).
E. Slide input shaft away from PTO shaft.
F. Remove bearing.
G. Remove thrust washer and gear by sliding input
shaft toward PTO shaft.
H. Release shift arm from shifter block.
I. Remove input shaft assembly.
9. Disassemble PTO input shaft:
A. Remove shift collar.
B. Remove steel balls and spring.
Drive Train
1. Retaining ring
2. Retaining ring
3. Input shaft assembly
4. Bearing
5. Bearing
3. Input shaft assembly
6. Thrust washer
1
1. Shift collar
2. Steel ball (2)
Page 6 − 58
Moly disulfide
grease
Figure 117
6. Thrust washer
7. Gear
8. Shift arm
9. Shifter block
8
6
7
Figure 118
7. Gear
8. Shift arm
2
3
2
Figure 119
3. Spring
Workman HD Series
3