Checking The Transaxle-Fluid Level - Toro 07413LT Operator's Manual

Adjusting the Front Wheel Toe-in
Important:
Before adjusting toe-in, ensure that
the camber adjustment is as close to neutral as
possible; refer to Adjusting the Camber (page
1. Measure the distance between both of the front
tires at the axle height at both the front and rear
of the front tires (Figure
Figure 51
1. Tire center line—back
2. Tire center line—front
2. If the measurement does not fall within 0 to
6 mm (0 to 1/4 inch), loosen the jam nuts at the
outer end of the tie rods
Figure 52
1. Tie rod
3. Rotate both tie rods to move the front of the tire
inward or outward.
4. Tighten the tie rod jam nuts when the adjustment
is correct.
5. Ensure that there is full travel of the steering
wheel in both directions.
41).
51).
g009235
3. Axle center line
(Figure 52).
g033219
2. Jam nut
Checking the
Transaxle-Fluid Level
Service Interval: Every 100 hours—Check the
transaxle-fluid level.
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the motor and remove the key.
4. Remove the fill plug on the transaxle
Note:
The fluid level should be even with the
bottom of the fill plug.
1. Fill plug
5. If the fluid level is low, remove the fill plug and
add the specified fluid until it runs out of the hole
(Figure 53).
6. Install the fill plug and torque it to 20 to 27 N∙m
(15 to 20 ft-lb).
42
(Figure
Figure 53
53).
g217835