Riser Board - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.1.12 Riser Board

To remove the riser board, complete the following steps:
1. Perform the preparation procedures described in Section 5.1.3.
2. Remove the system unit cover (Section 5.1.6).
3. Remove all expansion boards (Section 5.1.8).
4. Remove the two screws that secure the riser board to the riser brace.
5. Tilt the riser board slightly away from the riser brace and pull up.
Figure 5-26. Removing the Riser Board
To replace the riser board, reverse the above procedure.
5-30 Removal and Replacement Procedures