Riser Brace - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.1.13 Riser Brace

The riser brace should only be removed from the computer if it has been damaged.
To remove the riser brace, complete the following steps:
1. Perform the preparation procedures in Section 5.1.3.
2. Remove the system unit cover (Section 5.1.6).
3. Remove the expansion boards (Section 5.1.8)
4. Remove the riser board (Section 5.1.12).
5. Remove the two screws that secure the riser brace to the chassis and lift the brace straight up.
Figure 5-27. Removing the Riser Brace
To install the riser brace, reverse the above procedures.
Compaq Deskpro 2000 5-31