Compaq DESKPRO 2000 SERIES Maintenance & Service Manual page 44

3. To disable or clear the power-on password, move the jumper plug on E6 from pins 5 and 6 to pins 6
and 7 and then restart the computer.
To enable the power-on password, turn the computer off, then move the jumper plug from pins 6
and 7 to pins 5 and 6 and restart the computer. The password can then be reestablished through
Security Management.
The E6 jumper location is shown in Figure 2-1.
Figure 2-1. Locating the E6 Jumper on the System Board
4. Replace the hood or access panel and perform the desired troubleshooting.
5. The password can then be reestablished through Security Management.
2-2 Troubleshooting