Compaq DESKPRO 2000 SERIES Maintenance & Service Manual page 193

4. Insert a memory module at a 45-degree angle into a memory socket on the system board.
A memory module can only be installed one way. Match the notch on the module with the tab on the
memory socket. Push the module down into the socket, ensuring that the module is fully inserted and
properly seated.
Figure 5-73. Installing a Memory Module
5. Rotate the module to an upright position, allowing the latches to snap into place.
6. Repeat steps 4 and 5 for each module that you want to install.
7. Replace the access panel.
8. The computer recognizes system memory upgrades and automatically reconfigures the computer. If,
for some reason, the memory upgrades do not configure correctly, run Computer Setup to
reconfigure the computer. Refer to Chapter 7, "Compaq Utilities," for information on running
Computer Setup.
9. Test the system (optional) using the Computer Checkup (TEST) utility. Refer to Chapter 2,
"Troubleshooting."
5-80 Removal and Replacement Procedures