Outboard Expansion Board - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.1.8.2

Outboard Expansion Board

To remove an outboard expansion board, complete the following steps:
1. Perform preparation procedures described in Section 5.1.3.
2. Remove the system unit cover. (Section 5.1.6).
3. Remove the retaining screw that secures the board to the rear of the computer.
4. Remove the expansion board.
Figure 5-13. Removing an Expansion Board
To install an outboard expansion board, complete the following steps:
1. Slide the expansion board into the expansion slot and press it firmly into place.
2. Replace the retaining screw.
If you are installing an expansion board for the first time in an outboard position, remove the
retaining screw and the expansion board cover before installing the board.
3. Replace the system unit cover.
4. To reconfigure the computer to recognize the added expansion board, run the Computer Setup utility.
Refer to Chapter 7, "Compaq Utilities."
5. Test the computer (optional) using the Computer Checkup (TEST) utility. Refer to Chapter 2,
"Troubleshooting."
Compaq Deskpro 2000 5-15