Led Cable - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.2.21 LED Cable

To remove the LED cable, complete the following steps:
1. Perform the preparation procedures described in Section 5.2.3.
2. Remove the access panel (Section 5.2.6.1).
3. Remove the riser brace (Section 5.2.7).
4. Disconnect the cable from the connection on the system board.
5. Remove the LED end of the cable from the front of the chassis by gently pulling on the cable while
at the same time pushing the end of the LED from the front of the chassis.
Figure 5-103. Removing the LED Cable From the Pentium (Top) and Pentium Pro (Bottom) System
Boards
5-112 Removal and Replacement Procedures