Expansion Board Components; Matrox Mga Millennium Graphics Controller - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.2.10 Expansion Board Components

5.2.10.1 Matrox MGA Millennium Graphics Controller

To install additional WRAM onto the Matrox MGA Millennium Graphics board, complete the
following steps:
1. Perform preparation procedures described in Section 5.1.3.
2. Remove the access panel (Section 5.2.6.1).
3. Remove the expansion board (Section 5.2.8).
4. Place the graphics board on a flat surface and install the upgrade module.
Ensure that all pins on the connector are properly aligned to avoid damaging the memory module
and/or the graphics controller.
If you are removing a memory module, rock the module gently while pulling it up.
Figure 5-66. Installing a WRAM Upgrade Module on the Graphics Board
5. Replace the graphics controller board in the same expansion slot, securing it with the previously
removed screw.
6. Replace the access panel.
7. Turn on the computer and start the Windows program.
8. Select the Display icon in the Compaq Utilities group box in Windows NT 3.51 or Windows 3.1, or
the Display icon in Windows 95, to take advantage of the additional display modes now available
with the upgraded memory. Follow the instructions on the screen.
9. Test the system (optional) using the Computer Checkup (TEST) utility. Refer to Chapter 2,
"Troubleshooting."
Compaq Deskpro 2000 5-71