Table of Contents
Advertisement
e Clip information
During shooting, displays information about the
clip being recorded or the clip to be recorded next.
During playback, displays information about the
playback clip.
The information that appears depends on the
setting of DISP CLIP NAME on the VF DISP 3
page of the OPERATION menu. You can also set
DISP CLIP NO(PB) on the VF DISP 2 page of the
OPERATION menu to "ON" to display the clip
number and total number of clips during
playback.
When DISP CLIP NAME is set to "PLAN":
During shooting, when Planning Clip Name
Display in the Disc Menu is set to "Enable",
this area displays the title specified in the
currently loaded planning metadata. (The
display format follows the setting of
"Planning Clip Name in Clip Info. Area" in
the Disc Menu.)
When DISP CLIP NAME is set to "AUTO":
During shooting, this area displays one of the
following, depending on the setting of
AUTO NAMING on the FILE NAMING
page of the OPERATION menu.
• "C****" or "TITLE": The clip name
(standard name, user-specified name, or
title) specified by "Display Title" in the
Disc Menu
• "PLAN": During shooting, when Planning
Clip Name Display in the Disc Menu is set
to "Enable", the title specified in the
currently loaded planning metadata. (The
display format follows the setting of
"Planning Clip Name in Clip Info. Area" in
the Disc Menu.)
During playback, this area displays the clip
name (standard name, user-specified name,
or title) specified by "Display Title" in the
Disc Menu.
The following characters can be displayed in this
area.
• Digits: 0 to 9
• Alphabetic characters: a to z, A to Z
• The following symbols: !, ", #, $, %, &, ', (, ), *,
+, , (comma), -, . (period), /, : (colon), ;
(semicolon), <, =, >, ?, @, [, ], ^, _, {, |, }, ~
• Space
f Wireless microphone reception level
When a UHF portable tuner is installed in the
camcorder, "W" appears together with four-
segment reception level indicators for each of the
channels (1 or 2 channels) that can be used by the
tuner. The indications are as follows.
Normal use: The number of white segments
indicates the strength of the signal level.
Muted: The number of gray segments indicates
the strength of the signal level.
Reception level over peak: "P" is displayed
instead of the indicators.
Tuner battery is low: The channel number and
indicator of the corresponding channel
1)
flash.
1) DWR-S01D only
g Power source voltage/battery
remaining capacity
When the unit is powered from a battery pack,
indicates the remaining capacity of the power
source voltage. When the unit is powered from a
battery connected to the DC IN connector or AC
adaptor attached to the battery attachment shoe,
indicates the power source voltage.
h External battery
Appears if the power is supplied from an AC
adaptor connected to the DC IN connector.
i Clip Continuous Rec function
Appears when the Clip Continuous Rec function
(see page 87) is enabled.
CONT (lit): Continuous recording to extend the
previous clip is possible.
CONT (flashing): A new clip will be created and
recorded.
j Cooling fan control mode
This appears when FAN CONTROL on the CAM
CONFIG 2 page of the MAINTENANCE menu
is set to "R.MIN" or "MIN".
FAN (lit): The cooling fan is operating at low
speed.
FAN (flashing): The cooling fan is operating at
low speed, but the temperature inside the unit
has risen to a level just below the level at
which an alarm occurs.
Note
If you do nothing while the FAN display is flashing, the
unit will attempt to lower the internal temperature by
operating the fan at high speed. When the FAN display
Locations and Functions of Parts and Controls
1)
29
Advertisement
Table of Contents
