Table of Contents
Advertisement
Use the GENLOCK page of the
MAINTENANCE menu to adjust the genlock
H-phase (phase of horizontal sync signal).
Available reference signals vary depending on
the current system frequency as shown in the
following table.
System frequency
1080/59.94i
1080/50i
• This connector also inputs a return video signal.
You can display the HD-Y (1080i) signal in the
viewfinder screen while holding the RET button
down with RETURN VIDEO set to ON on the
ASSIGNABLE SW page of the OPERATION
menu.
• Input an external video signal. When the
optional CBK-SC02 Analog Composite Input
Board is installed, the unit can record analog
composite video signals that are input to this
connector.
e TC IN (timecode input) connector
(BNC type)
To apply an external lock to the timecode of this
unit, input the reference timecode.
For details of timecode, see "Setting the timecode"
on page 67.
f TEST OUT connector (BNC type)
This connector outputs the video signal for a
video monitor. The output signal can be selected
from composite video, HD-Y, R/G/B, and a
composite video signal like that displayed in the
LCD status monitor. To switch output signals, use
the TEST OUT SELECT item on the OUTPUT 1
page of the OPERATION menu.
If the output signal is set to one of R, G, or B, then
this setting changes to HD-Y when the camcorder
is powered off and on again.
Depending on menu settings, menus, timecode,
and shot data can be superimposed on the image
on the monitor. This connector can also be used to
synchronize the timecode of an external VTR
with the timecode of the camcorder.
g TC OUT (timecode output) connector
(BNC type)
To lock the timecode of an external VTR to the
timecode of this unit, connect this connector to
the external VTR's timecode input connector.
24
Locations and Functions of Parts and Controls
Available reference
signals
1080/59.94i, 525/59.94i
1080/50i, 625/50i
Rear
5
6
AUDIO IN
AES/EBU
LINE
MIC
48V
DC OUT
OFF
12V
0.5A
DC
IN
SUPER
CH1
1/2
SDI OUT
SDI OUT
8 9 0
a TALLY (back tally) indicator (red)
Lights up during recording. It will not light if the
TALLY switch is set to OFF. This indicator also
flashes to indicate warnings (see page 17) in the
same manner as the REC/TALLY indicator in the
viewfinder.
For details, see "Operation Warnings" on page 246.
b TALLY switch
Set to ON to activate the TALLY indicator
function.
c USB connector
This is a USB 2.0 connector.
Connect one of the following devices, depending
on what you want to do.
1
2
3
4
7
AES/EBU
LINE
MIC
48V
OFF
AUDIO OUT
CH2
3/4
qa
qs
qd
Advertisement
Table of Contents
