Download  Print this page

Sony PDW-680 Operation Manual Page 250

Professional disc camcorder.
Hide thumbs

Advertisement

AUTO
The unit is operating in Auto
INTERVAL
Interval Rec mode (**M**S:
**M**S
Indicates the shooting interval in
minutes and seconds).
MANU
The unit is operating in the single-
INTERVAL
shot mode of Manual Interval Rec
*FRAME
mode (*FRAME: Indicates the
number of frames recorded in one
shot).
INTERVAL
The unit is operating in the
**S (M/H)
consecutive mode of Manual
*FRAME
Interval Rec mode (**S (M/H):
Indicates the trigger interval, in
seconds (minutes or hours),
*FRAME: Indicates the number
of frames recorded in one shot).
LOW LIGHT Depending on the setting, the
subject illumination is inadequate.
ON-BOARD
The backup battery of the internal
BATTERY
clock is empty.
EMPTY
DCP
If this message continues to
EEPROM
appear even after the unit is
DATA NG!
powered off and on again several
DR EEPROM
times, then the factory adjustment
DATA NG!
data is invalid. Contact a Sony
DCP/DR
service representative.
EEPROM
DATA NG!
a) Contact a Sony service representative to replace the
battery.
VDR operation messages are displayed in the
setting change and adjustment progress message
display area of the viewfinder screen (see
page 30). Take the actions listed in the following
table.
ILL. Disc!
A disc that cannot be used by this
unit was inserted. Insert another
Professional Disc.
ILL. Index!
Index file or file system error.
No FS!
Exchange or format the disc.
Unknown FS!
No Support!
A recorded clip cannot be handled
by this unit. Exchange or format
the disc.
FORMAT
The disc could not be formatted
NG!
automatically. Exchange the disc.
250
Operation Warnings
a)
Disc Damage
A disc that cannot be recorded was
inserted. To record, exchange the
disc.
Non AV Full
The disc is full. Exchange or
MAX # Files
format the disc.
Over DUR!
DI read err
The disc was not recognized. Try
Read err
ejecting the disc and inserting it
DRV ADJ err
again. Or exchange the disc.
Run Salvage
A disc that requires salvage was
inserted. To record on the disc,
eject the disc, insert it again, and
execute salvage processing.
Salvage NG!
Salvage processing failed.
For details, see "Handling of discs
when recording does not end
normally (salvage function)" on
page 73.
Salvage
The loaded disc cannot be
XXXX
salvaged by this unit. The
"XXXX" in the message is a code
for XDCAM devices that can
salvage the disc. Refer to the list
of device codes (see page 74) and
salvage the disc using one of the
indicated devices.
REC INHI.!
The Write Inhibit tab of the disc is
in the recording disabled position,
or salvage processing needs to be
done on the loaded disc. Set the
tab to the recording enabled
position. Or eject the disc, insert it
again, and perform salvage
processing.
1080/50i
This appears when mixed format
1080/59.94i
recording mode is disabled and the
625/50i
current resolution or system
525/59.94i
frequency setting of this unit does
not match the resolution or system
frequency of the inserted disc. To
carry out recording operations,
exchange the disc, or change the
resolution or system frequency
setting of this unit, or enable
mixed format recording mode.

Advertisement

Table of Contents

   Also See for Sony PDW-680

   Related Manuals for Sony PDW-680

Comments to this Manuals

Symbols: 0
Latest comments: