Table of Contents
Advertisement
2
Select the position to which to assign a
CC filter by selecting one of
"ELECTRICAL CC<A>" to
"ELECTRICAL CC <D>", and then
turn the MENU knob to select the
desired color temperature.
As you turn the MENU knob, the color
temperature changes as follows: 3200K y
4300K y 5600K y 6300K.
To set no color temperature
Select "-----" with ELECTRICAL CC<C> or
<D> selected.
When the ASSIGN switch is pressed, the
setting for that position is not displayed. For
example, if "-----" is set for one position, then
switching between the remaining three
positions is carried out.
3
Repeat step 2 as required.
4
Assign the electrical CC filter switching
function (ELECTRICAL CC) to an
ASSIGN 1/3/4 switch, the COLOR
TEMP. button, or the RET button on
the lens (see page 204).
White balance memory
Values stored in memory are held until the white
balance is next adjusted.
There are two sets of white balance memories, A
and B, and adjustments for each of the ND filters
can be automatically stored in the memory
corresponding to the setting (A or B) of the
WHITE BAL switch. The camcorder has four
built-in ND filters, so a total of eight (4 × 2)
adjustments can be stored. However, the memory
contents are not linked to the ND filter settings in
the following cases.
• When the number of memories allocated to
each of A and B is limited to one by setting the
FILTER WHT MEM item on the WHITE
SETTING page of the OPERATION menu to
OFF.
• When the electrical CC filter switching function
has been assigned to an ASSIGN switch, or
when a remote control unit has been connected.
(In these cases, the contents of white balance
memory are linked to electrical CC filter
positions (A to D).)
If the WHITE BAL switch is set to B, and on the
WHITE SETTING page of the OPERATION
58
Adjusting the Black Balance and the White Balance
menu, the WHITE SWITCH <B> item is set to
"ATW (Auto Tracing White Balance)", the ATW
function is activated to automatically adjust the
white balance of the picture being shot for
varying lighting conditions.
To save white balance settings obtained by ATW
Set ATW HOLD MEMORY in the WHITE
SETTING page of the OPERATION menu to
"ON". When this is done, auto white balance
settings obtained by ATW are written to the
memory corresponding to the setting (A or B) that
is currently selected with the WHITE BAL
1)
switch.
You can then turn ATW off and continue
shooting with the current white balance values.
The unit continues to use the values that were in
effect immediately before ATW was turned off.
1) This function is not available when the WHITE BAL
switch is set to PRST. If you have connected a remote
control unit, the unit uses the memory corresponding
to the remote control unit setting (A, B, or C).
Advertisement
Table of Contents
