System Frequency And Frame Rate; Wireless Microphone Reception Level - Sony PDW-F800 Operation Manual

+: The value of OFFSET WHT is greater than
3200K.
–: The value of OFFSET WHT is less than
3200K.
b Video format
Indicates the format of video being currently
played back or recorded (see page 59).
The video aspect ratio (16:9 or 4:3) can also be
displayed when the recording format is set to
IMX 50, IMX 40, IMX 30, or DVCAM.
c Extender
Displays the extender settings of this unit and the
lens.
EX: The lens extender is on.
08: The lens shrinker is on.
x2D: This unit's extender function is on.
Ex2D: The lens extender and the digital extender
function of this unit are both on.
d Zoom position
Indicates the zoom position of the zoom lens in
the range from 0 to 99.
e Clip information
Displays clip information during playback.
During clip playback and search (when title
display is off): Displays the clip number and
total number of clips.
During clip playback and search (when title
display is on): Displays the title specified in
planning metadata as the clip name,
according to the setting of Planning Clip
Name in Clip Info. Area in the Disc Menu
(see page 139).
During clip list playback: Displays the name of
the clip list, the sub clip number, and the total
number of sub clips.
[F800]
f System frequency and frame rate
During Slow & Quick Motion shooting and
playback, displays the system frequency and the
frame rate. The frame is rounded to a 2-digit
integer and displayed in brackets ([ ]) (see page
95).
This display does not appear during normal
shooting and playback.
g Wireless microphone reception level
When a UHF portable tuner is installed in the
camcorder, "W" appears together with four-
segment reception level indicators for each of the
channels (1 or 2 channels) that can be used by the
tuner. The indications are as follows.
Normal use: The number of white segments
indicates the strength of the signal level.
Muted: The number of gray segments indicates
the strength of the signal level.
Reception level over peak: "P" is displayed
instead of the indicators.
Tuner battery is low: The channel number and
indicator of the corresponding channel
1)
flash.
1) DWR-S01D only
h Power source voltage/battery
remaining capacity
When the unit is powered from a battery pack,
indicates the remaining capacity of the power
source voltage. When the unit is powered from a
battery connected to the DC IN connector or AC
adaptor attached to the battery attachment shoe,
indicates the power source voltage.
i External battery
Appears if the power is supplied from an AC
adaptor connected to the DC IN connector.
j Clip Continuous Rec function
Appears when the Clip Continuous Rec function
(see page 97) is enabled.
CONT (lit): Continuous recording to extend the
previous clip is possible.
CONT (flashing): A new clip will be created and
recorded.
k Cooling fan control mode
This appears when FAN CONTROL on the CAM
CONFIG 2 page of the MAINTENANCE menu
is set to "R.MIN" or "MIN".
FAN (lit): The cooling fan is operating at low
speed.
FAN (flashing): The cooling fan is operating at
low speed, but the temperature inside the unit
has risen to a level just below the level at
which an alarm occurs.
Note
If you do nothing while the FAN display is flashing, the
unit will attempt to lower the internal temperature by
operating the fan at high speed. When the FAN display
begins to flash, you should stop shooting and other
operations and wait until the internal temperature drops,
and then restart operations.
Locations and Functions of Parts and Controls
1)
35