Optiview VR4HT User Manual page 166

Please refer to the following sheet for detailed information.
Parameter Function
Event The abnormal events include: no disk, no space, disk error, net error, IP
Type conflict, MAC conflict.
You need to draw a circle to enable this function.
Normal The corresponding alarm activation output channel when alarm occurs,
Out There are six channels.
The alarm output can delay for the specified time after alarm stops.
Latch
Then system disables alarm and corresponding activation output.
The value ranges from 10s to 300s.
Send If you enable this function, system can send out email to alarm the
email specified user.
Alarm System can upload the alarm signal to the network (includes the alarm
upload centre.)
Show System pops up the alarm messages in the monitor interface.
message
Buzzer Once you check the box here, the buzzer beeps when an alarm
occurred.
7.5.3.8 Matrix Spot
Here you can set tour channel and corresponding interval. You can set 1/4/9/16-window spot tour.
See Figure 7-56.
Please note only 1.5U and 2u series product support video matrix function and it shall be 1-
window spot tour.
Figure 7-55
156