Optiview VR4HT User Manual page 152

Parameter
NAS enable
Server IP
Port
User Name
File length
Password
Remote Path
Save
Refresh
NTP
The NTP interface is shown as in Figure 7-39.
Here you can realize network time synchronization. Please enable current function and then
input server IP, port number, time zone and update interval. Please note the SNTP supports TCP
transmission only and its port shall be 123.The update interval ranges from 1 to 65535. Default
value is 10 minutes.
Function
Please select network storage protocol and then enable
NAS function.
Input remote storage server IP address.
Input Remote storage server port number.
Log in user account.
The file length you upload to the FTP.
When setup is larger than the actual file length, system
will upload the whole file. When setup here is smaller
than the actual file length, system only uploads the set
length and auto ignore the left section. When interval
value is 0, system uploads all corresponding files.
The password you need to log in the server.
Remote storage file path.
You can click save button after you complete setup for
one channel, or you can complete the whole setups and
then click save button.
Click this button to get device latest configuration
information.
Figure 7-39
142