Activate Pattern Function; Border Setup; Activate Border Function; Flip - Optiview VR4HT User Manual

Please go to Figure 6-2
X417H417 H417 H
button.
You can memorize all these setups as pattern 1.

6.2.6 Activate Pattern Function

In Figure 6-6 input mode value in the No. blank, and click pattern button.
X 4 1 9 H 4 1 9 H 419 H X

6.2.7 Border Setup

In Figure 6-5 , click border button. The interface is shown as in
X 4 2 0 H 4 2 0 H 420 H X
Please go to Figure 6-2
X422H422 H422 H
Figure 6-10 and click left limit button
X 4 2 3 H 4 2 3 H 4 2 3H X
Repeat the above procedures to set right limit.

6.2.8 Activate Border Function

In Figure 6-6 , click auto scan button, the system begins auto scan. Correspondingly, the auto
X 4 2 4 H 4 2 4 H 424 H X
scan button changes to stop button.
Click stop button to terminate scan operation.
6.2.9

Flip

In Figure 6-6 , click page switch button, you can see an interface is shown as below. See
X 4 2 5 H 4 2 5 H 425 H X
Figure 6-11 . Here you can set auxiliary function.
X 4 2 6 H 4 2 6 H 4 2 6H X
Click page switch button again, system goes back to
to modify zoom, focus, and iris. Go back to
X
Figure 6-9
, use direction arrows to select camera left limit, and then please go to
X
Figure 6-10
Figure 6-9
X418H418H 418H
Figure 6-10
X421H421H 421H
Figure 6-2 .
X 4 2 7 H 4 2 7 H 427 H X
and click end
X
.
X
114