Grandstream Networks UCM6510 IP PBX User Manual page 159

Default Destination
Strip
Prepend
Prepend Trunk Name
Dial Trunk
DID Destination
Firmware Version 1.0.1.12
This setting is used to compare with the outbound trunk's permission level
when the inbound call dials out via a trunk on the UCM6510. Therefore, it's
usually used only when the "Default Destination" is set to "By DID".
Select the default destination for the inbound call.

Extension

Voicemail

Conference Room

Call Queue

Ring Group

Paging/Intercom

Voicemail Group

Fax

DISA

IVR

By DID
When "By DID" is used, the UCM6510 will look for the destination
based on the number dialed, which could be local extensions,
conference, call queue, ring group, paging/intercom group, IVR,
voicemail groups and Fax extension as configured in "DID
destination". If the dialed number matches the DID pattern, the call will
be allowed to go through.

Dial By Name
Specify the number of digits to strip from the beginning of the DID. This is
used when "By DID" is selected in "Default Destination".
Specify the digits to be prepended before the call is placed via the trunk.
Those digits will be prepended after the dialing number is stripped.
If enabled, the trunk name will be added to the caller id name as the
displayed caller id name.
Configure to allow the inbound call to dial out from the PBX's trunk or not.
The default setting is disabled. Please be aware of potential security risk if
"Dial Trunk" is enabled. The inbound call might be able to dial out
international calls from the PBX's trunk if allowed by the privilege level.
Select the DID destination if "By DID" is selected in "Default Destination".
Only the selected category can be reached by DID using this inbound
route.

Extension

Conference

Call Queue

Ring Group
UCM6510 IP PBX User Manual Page 157 of 277