Grandstream Networks UCM6510 IP PBX User Manual page 103

Auth ID
TEL URI
Ring Simultaneously
Ring Simultaneously
External Number
Time Condition for Ring
Simultaneously
Other Settings
SRTP
Fax Detection
Skip Trunk Auth
Dial Trunk Password
Strategy
Firmware Version 1.0.1.12
Configure the authentication ID for the user. If not configured, the
extension number will be used for authentication.
If the end device/phone has an assigned PSTN telephone number, this
field should be set to "User=Phone". Then a "User=Phone" parameter will
be attached to the Request-Line and TO header in the SIP request to
indicate the E.164 number. If set to "Enable", "Tel:" will be used instead of
"SIP:" in the SIP request. The default setting is disabled.
Once this mode is enabled, it will allow the user's extension and external
number ring simultaneously during an incoming call. If user used register
trunk for outbound call, the caller will display the register number. This
mode is disabled by default.
Once this number is set and Ring Simultaneously mode is enabled, for an
incoming call, both external and extension number will be ringed
simultaneously. The "-" will be ignored in the field when the external
number is filled in.
Select time condition for Ring Simultaneously. The available time condition
are "All Time", "Office Time", "Out of Office Time", "Holiday", "Out of
Holiday", "Out of Office Time or Holiday" and "Specific Time".
Enable SRTP for the call. The default setting is disabled.
Enable to detect Fax signal from the user/trunk during the call and send
the received Fax to the Email address configured for this extension. If no
Email address can be found for the user, send the received Fax to the
default Email address in Fax setting page under UCM6510 web
GUI->PBX->Internal Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
If enabled, users will not need to enter the password required by the
outbound rule to make outbound calls. The default setting is "No".
Configure personal password when making outbound calls via trunk.
This option controls how the extension can be used on devices within
different types of network.

Allow All
Device in any network can register this extension.

Local Subnet Only
Only the user in specific subnet can register this extension. Up to three
subnet addresses can be specified.
UCM6510 IP PBX User Manual Page 101 of 277