Batch Add Extensions; Batch Add Sip Extensions - Grandstream Networks UCM6510 IP PBX User Manual

Skip Trunk Auth
Dial Trunk Password
Strategy
Codec Preference
Specific Time
Time Condition

BATCH ADD EXTENSIONS

BATCH ADD SIP EXTENSIONS

In order to add multiple SIP extensions, BATCH add can be used to create standardized SIP extension
accounts. However, unique extension user name can't be set using BATCH add.
Under web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
SIP Extensions".
Firmware Version 1.0.1.12
default Email address in Fax setting page under web GUI->PBX->Internal
Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
If enabled, users will not need enter the "PIN Set" required by the
outbound rule to make outbound calls. The default setting is "No".
Configure personal password when making outbound calls via trunk.
This option controls how the extension can be used on devices within
different types of network.

Allow All
Device in any network can register this extension.

Local Subnet Only
Only the user in specific subnet can register this extension. Up to three
subnet addresses can be specified.

A Specific IP Address
Only the device on the specific IP address can register this extension.
The default setting is "Allow All".
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, ILBC,
ADPCM, H.264, H.263 and H.263p. In the selected codec list, users can
click on UP or DOWN arrow to adjust the order for the codec priority.
Click to add Time Condition to configure specific time for this extension.
UCM6510 IP PBX User Manual Page 106 of 277