Static Routes; Table 6: Ucm6510 Network Settings->802.1X; Figure 11: Ucm6510 Using 802.1X Eap-Md5 - Grandstream Networks UCM6510 IP PBX User Manual

The following table shows the configuration parameters for 802.1X on UCM6510. Identity and MD5
password are required for authentication, which should be provided by the network administrator obtained
from the RADIUS server. If "EAP-TLS" or "EAP-PEAPv0/MSCHAPv2" is used as the 802.1X mode, users
will also need upload 802.1X CA Certificate and 802.1X Client Certificate, which should be also generated
from the RADIUS server.
802.1X Mode
Identity
MD5 Password
802.1X CA Certificate
802.1X Client
Certificate

STATIC ROUTES

A static route is a pre-determined path that the network traffic travels to reach a specific host or network.
On the UCM6510, the static route function allows the device to use manually configured routes, rather than
dynamically assigned routes or default gateway configured in the UCM6510 web GUI->Network
Firmware Version 1.0.1.12

Figure 11: UCM6510 Using 802.1X EAP-MD5

Table 6: UCM6510 Network Settings->802.1X
Select 802.1X mode. The default setting is "Disable". The supported 802.1X mode
are:

EAP-MD5

EAP-TLS

EAP-PEAPv0/MSCHAPv2
Enter 802.1X mode identity information.
Enter 802.1X mode MD5 password information.
Select 802.1X certificate from local PC and then upload.
Select 802.1X client certificate from local PC and then upload.
UCM6510 IP PBX User Manual Page 41 of 277