Table 30: Batch Add Sip Extension Parameters - Grandstream Networks UCM6510 IP PBX User Manual

General
Start Extension
Create Number
Permission
Enable Voicemail
SIP/IAX Password
Voicemail Password
Ring Timeout
Auto Record
Skip Voicemail Password
Firmware Version 1.0.1.12

Table 30: Batch Add SIP Extension Parameters

Configure the starting extension number of the batch of extensions to be
added.
Specify the number of extensions to be added. The default setting is 5.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule. If the
outbound rule privilege is disabled, this option will not take effect.
Enable Voicemail for the user. The default setting is "Yes".
Configure the SIP/IAX password for the users. Two options are available to
create password for the batch of extensions.

User Random Password.
A random secure password will be automatically generated. It is
recommended to use this password for security purpose.

Enter a password to be used on all the extensions in the batch.
Configure Voicemail password (digits only) for the users.

User Random Password.
A random password in digits will be automatically generated. It is
recommended to use this password for security purpose.

Enter a password to be used on all the extensions in the batch.
Configure the number of seconds to ring the user before the call is
forwarded to voicemail (voicemail is enabled) or hang up (voicemail is
disabled). If not specified, the default ring timeout is 60 seconds on the
UCM6510, which can be configured in the global ring timeout setting under
web GUI->Internal Options: General Preference. The valid range is
between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout
used is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files will be saved in external storage if
plugged in and can be accessed under web GUI->CDR->Recording Files.
When user dials voicemail code, the password verification IVR is skipped.
UCM6510 IP PBX User Manual Page 107 of 277