Iax Settings/Static Defense; Table 69: Iax Settings/Static Defense - Grandstream Networks UCM6510 IP PBX User Manual

IAX Thread Count
IAX Max Thread Count
Auto Kill
Authentication Debugging
Codec Priority
Type of Service
IAX Trunk Options
Trunk Frequency
Trunk Time Stamps

IAX SETTINGS/STATIC DEFENSE

Call Token Optional
Max Call Numbers
Firmware Version 1.0.1.12
Configure the number of IAX helper threads. The default setting is 10.
Configure the maximum number of IAX threads allowed. The default
setting is 100.
If set to "yes", the connection will be terminated if ACK for the NEW
message is not received within 2000ms. Users could also specify number
(in milliseconds) in addition to "yes" and "no". The default setting is "yes".
If enabled, authentication traffic in debugging will not show. The default
setting is "No".
Configure codec negotiation priority. The default setting is "Reqonly".

Caller
Consider the callers preferred order ahead of the host's.

Host
Consider the host's preferred order ahead of the caller's.

Disabled
Disable the consideration of codec preference all together.

Reqonly
This is almost the same as "Disabled", except when the requested
format is not available. The call will only be accepted if the requested
format is available.
Configure ToS bit for preferred IP routing.
Configure the frequency of trunk frames (in milliseconds). The default
setting is 20.
If enabled, time stamps will be attached to trunk frames. The default setting
is "No".

Table 69: IAX Settings/Static Defense

Enter a single IP address or a range of IP addresses for which call token
validation is not required.
For example:
11.11.11.11
11.11.11.11/22.22.22.22.
Configure the maximum number of calls allowed for a single IP address.
UCM6510 IP PBX User Manual Page 228 of 277