Table of Contents
Advertisement
•
Charging the battery (see page 26)
•
Folding up the backrest (see page 15)
•
Installing the arm supports (see page 14)
6.3 Settings
The user or attendant may only perform the fine-tuning adjustments described in the following. The user should be
sitting upright in the power wheelchair while making adjustments.
•
Adjusting the back angle (see page 15)
•
Adjusting the height of the arm supports (see page 14)
•
Adjusting the positioning belt (lap belt) (see page 28)
Further adjustments may be made only by qualified personnel
All parts of the product should be cleaned thoroughly before adjustments are made.
6.3.1 Adjusting the control device
WARNING
Incorrect configuration of the control device
Falling, tipping over, collision due to incorrect parameter settings
► The parameter settings of the control device may only be changed by qualified personnel. The manufacturer of
the product and the control device manufacturer are not liable in case of damage caused by parameter set
tings that were incorrectly configured or not adjusted properly according to the user's abilities.
If necessary, the qualified personnel can adapt the preconfigured parameters of the wheelchair control device to
the specific requirements of the user.
7 Use
7.1 Operational readiness
INFORMATION
If the product will not be used for an extended period of time, the battery cable should be disconnected from the
plug connection on the controller.
Notice: As a rule, the plug connection between the battery and controller is already connected on delivery, and the
power wheelchair is therefore ready for operation.
If this is not the case, the plug connection has to be connected. The plug connection is below the back of the bat
tery cover.
3
7.2 Arm supports
CAUTION
Exposed pinch points
Pinching, crushing of limbs due to improper handling
► Do not reach into the danger area with your fingers when folding the arm supports up and down.
490E163=*
Connecting the battery cable
1) Take the plug of the battery cable in your hand. The
plug is located between the motors, below the bat
tery cover (see fig. 3, left).
2) Connect the plug to the plug connection on the
controller (see fig. 3, right).
Disconnecting the battery cable
1) Disconnect the plug of the battery cable from the
controller. To release the plug, push the snap-fit
(see fig. 3, item 1).
2) Let the battery cable hang down loosely (see fig. 3,
left).
Use
13
Advertisement
Table of Contents
