Tensioning The Spokes/Adjusting The Out-Of-Round; Retrofitting A Spoke Protector - Otto Bock Invader 480S26-20000_K Instructions For Use Manual

26

7.8.4 Tensioning the Spokes/Adjusting the Out-of-Round

INFORMATION
The assembly tasks described below may only be carried out by qualified personnel.
Tensioning the Spokes
1) Completely remove the tyre (see Fig. 27).
2) Check the spoke tension by shaking/moving the spokes.
3) If necessary, carefully adjust the tension of the spokes with spoke tensioner.
4) Completely reinstall the tyre.
Adjusting the Out-of-Round
Adjusting the out-of-round by a maximum of 1 mm requires special instruments and technical knowledge. The
adjustment should be performed in a bicycle specialist workshop.

7.8.5 Retrofitting a spoke protector

INFORMATION
The assembly tasks described below may only be carried out by qualified personnel.
The spoke protector serves to protect the spokes and prevents reaching into the rotating rear wheels.
Snap fasteners (attachment nipples) are used for installation.
1) Remove the rear wheels.
2) Position the spoke protector on the rim so that it is centred and you can see a spoke beneath each of the six
bore holes.
3) From the outside, press in the attachment nipples e.g. with a hammer handle until you hear them lock in place
on the spokes (see Fig. 28).
INFORMATION: Screw connections are required for installation in some versions (see Fig. 29).
28
Invader 480S26=20000_K
27
29
Use
Ottobock | 19