Adjusting The Quick-Release Axle; Retrofitting A Spoke Protector - Otto Bock Start M1 Instructions For Use (Qualified Personnel

4) Tighten the respective countered hexagon nut to 50 Nm.
4

6.2.4 Adjusting the Quick-Release Axle

The quick-release axle should be set so the wheel is correctly engaged, with no play on the axle.
1) Hold the quick-release axle respectively with a ring and open-ended wrench by the head (wrench size: 24 mm)
and by the tip (wrench size: 19 mm).
2) Adjust the play by turning the nut on the end of the quick-release axle (see fig. 5, item 1) in or out.
5

6.2.5 Retrofitting a spoke protector

The spoke protector serves to protect the spokes and prevents reaching into the rotating rear wheels.
Snap fasteners (attachment nipples) are used for installation.
1) Remove the rear wheels.
2) Position the spoke protector on the rim so that it is centred and you can see a spoke beneath each of the six
bore holes.
3) From the outside, press in the attachment nipples e.g. with a hammer handle until you hear them lock in place
on the spokes (see fig. 6).
INFORMATION: Screw connections are required for installation in some versions (see fig. 7).
Start M1
Settings
Ottobock | 11