Installing / Adjusting The Anti-Tipper And Tip-Assist; Installing The Accessory Mount; Installing The Anti-Tipper; Adjusting The Anti-Tipper - Otto Bock Voyager Evo Instructions For Use Manual

35

6.9 Installing / adjusting the anti-tipper and tip-assist

CAUTION
Missing anti-tipper
Tipping over, falling of the user due to missing safety devices
► If the back is tilted far to the rear and in the case of a short wheelbase, 2 anti-tippers (one on each side) must
be mounted and in a functional position; in the case of a long wheelbase, at least one anti-tipper must be
mounted and in a functional position.
► Check that the anti-tipper is securely attached.

6.9.1 Installing the Accessory Mount

The manufacturer offers an accessory mount for this product. This enables the installation of the anti-tipper and the
tip-assist. A special axle tube clamp is also needed to install the accessory mount (see fig. 37, item 1).
The accessory mount and special axle tube clamp – depending on the order – are supplied already installed.
It may be necessary to retrofit these components in the course of an initial fitting. To install these, see the 647G965
Service Manual.

6.9.2 Installing the anti-tipper

Depending on the order, the anti-tipper (see fig. 37, item 2) may already be installed when delivered.
It may be necessary to retrofit or reposition the anti-tipper in the course of an initial fitting. To install and adjust this,
see the 647G965 Service Manual.
37

6.9.3 Adjusting the Anti-Tipper

INFORMATION
In order to adjust the anti-tipper correctly, it may be necessary to combine the steps to adjust the length and
angle.
Adjusting the Length of the Pivot Arm
1) Remove the Allen head screw on the pivot arm (see fig. 39, item 1).
Voyager Evo
36
38
Settings
Ottobock | 21