*Turn the main switch to "ON".
lead at bulb socket connector.
This circuit is good.
7. When engine is hot, tempmeter does not move.
??
Disconnect the therm0 unit lead (Green/-
Red) @ .
??
Check that the tempmeter stays put at "C".
??
Ground the lead to the frame with the
jumper lead.
??
Turn the main switch to "ON".
??
Check that the tempmeter hand moves up
to "H".
MEETS
SPECIFICATION
I
INCORRECT
SIGNAL SYSTEM ppiq
OUT OF SPECIFICATION
5. Wiring connection
Check the entire signal system for
connections.
Refer to the "WIRING DIAGRAM"
section.
As soon as the meter hand get in the
"Red zone, turn the main switch to
"OFF" to avoid damage to the temp-
meter.
CORRECT
Check wiring connection.
1
I