Yamaha FZR400 1988-1989 Service Manual page 26

FRONT AND REAR BRAKE -1
3.
Remove:
Brake pads @
??
NOTE:
Replace the pad spring if the pad replacement
??
is required.
Replace the pads as a set if either is found to
??
be worn to the wear limit.
0.5 mm (0.02 in)
4. Install:
Brake pads @
??
Pad spring @
??
Installation
caliper bleed screw. Then, place the other
end of this hose into an open container.
Loosen the caliper bleed screw and push the
??
piston into the caliper by your finger.
*Tighten the caliper bleed screw.
Caliper bleed screw:
6 Nm (0.6 m- kg, 4.3 ft. lb)
*Install the brake pad (new) and pad spring
(new).
NOTE:
The arrow mark @ on the pad spring must
point in the disc rotating direction.
steps:
a suitable hose @ tightly to the