Yamaha FZR400 1988-1989 Service Manual page 28

FRONT AND REAR BRAKE b-l &I
4. Remove:
Brake pads (with shims) @
??
Pad spring @
??
NOTE :
Replace the pad spring if the pad replacement
??
is required.
Replace the pads as a set if either is found to
??
be worn to the wear limit.
Replace the pad shim if the pad replacement is
??
required.
0.5 mm (0.02 in)
5. Install:
Pad spring @
??
Brake pads (with shims) @
??
Installation
caliper bleed screw. Then, place the other
end of this hose into an open container.
Loosen the caliper bleed screw and push the
??
piston into the caliper by your finger.
*Tighten the caliper bleed screw.
Caliper bleed screw:
6 Nm (0.6 m - kg, 4.3 ft - lb)
@Install the brake pads (new), pad spring
(new) and pad shims (new).
NOTE:
Install pad shims @ and pad spring @ on
caliper as shown in the disc rotating direction.
steps: