Yamaha FZR400 1988-1989 Service Manual page 260

FRONT AND REAR BRAKE piqq
8. Fill:
Brake fluid
??
Recommended Brake Fluid:
If DOT # 4 is not available,
# 3 can be used.
Brake fluid may erode painted surfaces or plastic
parts. Always clean up spilled fluid immediately.
Use only the designated quality brake fluid.
??
otherwise, the rubber seals may deteriorate,
causing leakage and poor brake performance.
Refill with the same type of brake fluid;
??
mixing fluids may result in a harmful chemical
reaction and lead to poor performance.
Be careful that water does not enter the
??
master cylinder
significantly lower the boiling point of the
fluid and may result in vapor lock.
9. Install:
Rubber seal @
??
Master cylinder cap @
??
Screws (Master Cylinder Cap) :
2 Nm (0.2 m - kg, 1.4 ft- lb)
10. Air bleed:
Brake system
??
Refer to the
in the CHAPTER 3.
when refilling. Water
"AIR BLEEDING" section
will
I