DRIVE CHAIN SLACK ADJUSTMENT ADJ m
Clockwise
Counterclockwise
NOTE:
Turn each adjuster exactly the same amount
to maintain correct axle alignment. (There
marks on each side of swingarm; use them to
check for proper alignment.)
Tighten the locknut.
??
??
Tighten the axle nut to specification, while
pushing up or down on the chain to zero
slack.
107 Nm (10.7 m- kg, 77 ft. lb)
Install the cotter pin.
??
Always use a new cotter pin on the axle nut.
Do not loosen the axle nut after torque
tightening. If the axle nut groove is not
aligned with the cotter pin hole, align groove
nut.
is
decreased.
are