Table of Contents
Advertisement
ENGINE ASSEMBLY AND ADJUSTMENT
CYLINDER HEAD AND CAMSHAFT
1. Install:
@Gasket (Cylinder head) (New) @
Dowel pins @
??
NOTE:
The gasket "HEAD" mark should face upward.
NOTE:
in this manual, as follows:
Procedure 1.
??
The cam chain is disconnected + Connect.
@Procedure 2.
The camshafts are removed + Install.
Procedure 1
1. Install:
Camshafts, and cylinder head assembly
??
*Be sure the camshaft timing marks @ align
with the camshaft cap marks 0.
the stationary pointer when #l p i s t o n i s
at TDC.
2. Tighten:
Nuts (Cylinder head)
??
Use the Hexagon Wrench 6 mm (0.24 in)
NOTE:
Tighten the nuts in their proper tightening
sequence and torque nuts in two stages.
Nuts (Cylinder Head):
25 Nm (2.5 m-kg, 18 ft-lb)
Advertisement
Chapters
Table of Contents
