Steering Head - Yamaha FZR400 1988-1989 Service Manual

STEERING HEAD

??
becomes dry enough to make the grip and
handlebar stuck securelv.
AND HANDLEBAR CHAS &b
8. Install:
Handlebar bosses
??
NOTE:
Insert the pin on the handlebar bosses into the
corresponding hole on the handlebar crown.
9. Install:
Handlebars
??
Pinch Bolts
23 Nm (2.3 m-kg- 17 ft.lb)
10. Install:
*Clutch lever holder @
Handlebar switch (Left) @
??
Handlebar grip (Left) @
??
Handlebar grip end (Left) @
??
Handlebar (Left) installation
Install the lever holder with the punched
??
mark @ on the handlebar aligning with the
slit in the lever holder @ .
Bolt (Lever Holder) :
10 Nm (1.0
Install the handlebar switch (Left)
??
to the handlebar end, as shown.
mm (0.8 in)
Fit the handlebar grip fully over the handle-
bar end.
Leave the handlebar intact until the adhesive
(Handlebar):
steps:
I