KETRON SD1 User Manual page 98

F3 Modulation:
This calls up a new menu dedicated to the management of the Modulation Wheel. The parameters available are the following:
F1 LFO Pitch: When On, the Modulation Wheel controls the entry of the modulation of the LFO on the pitch to create
a cyclic vibrator. It can be set Off only if at least one modulation between DCF, DCA, Cutoff and WhaWha is enabled
so that the Modulation Wheel always controls a parameter.
F2 LFO DCF: When On, the Modulation Wheel controls the entry of the modulation on the LFO on the filter cut-off.
F3 LFO DCA: When On, the Modulation Wheel controls the entry of the modulation on the LFO on the amplitude to
create a cyclic tremolo.
F4 Cutoff: When On, the Modulation Wheel directly controls the filter cut-off. This proves useful to control the har-
monic richness of a timbre. It cannot be used if F6 Wha-Wha is already enabled.
F5 Escape: This returns to the initial page of the Utility menu.
F6 Wha-Wha: When On, the Modulation Wheel controls the Wha-Wha effect, typical of electric guitars. It cannot be
used if F4 Cutoff is already enabled.
F7 To Swell: When On, it transfers all the parameters controlled by the Modulation Wheel to the optional Volume
pedal.
F8 Mod. Rate: The value entered using the VALUE +/- push buttons defines the velocity of the LFO's used with the
Modulation Wheel
F9 Mod. Amou: The value entered using the VALUE +/- push buttons establishes the modulation depth that can be
obtained using the Modulation Wheel for the LFO's.
F4 Pitch:
This calls up a new menu dedicated to controlling the tuning. The parameters available are the following:
F1 Tune: The value indicated in Hertz, that can be modified +/- 100 Cents using the VALUE +/- push buttons, estab-
lishes the fine tuning of the whole sound generator of the SD1. By pressing the two VALUE +/- push buttons togeth-
er at the same time the standard tuning of 440 Hz is reset.
F2 Vibrato: When Off, it disables the vibrato on the timbres that use it. The sampled vibrato of some timbres is not
affected by the setting of this parameter.
F3 Portament: The value set using the VALUE +/- push buttons controls the Portamento velocity.
F4 Legato: When On, the Portamento between two notes is monophonic and is achieved only when the two notes
are played with note ligature. When Off, the Portamento is polyphonic and is produced even when the two notes are
played separately. The tied notes function is extremely interesting to simulate the phrasing of some traditional
soloist instruments, such as violins, trumpet, horn and trombone.
F5 Escape: This returns to the initial page of the Utility menu.
F6 Bend Valu: The value entered using the VALUE +/- push buttons establishes the excursion semitones of the Pitch
Bend Wheel.
F7 Bend LFO: This assigns the vibrato control created with the LFO to the Pitch Bend Wheel, the intensity of which
is established by the value that can be modified using the VALUE +/-push buttons.
F8 Bend DCF: This assigns the filter cut-off control to the Pitch Bend Wheel, the intensity of which is established by
the value that can be modified using the VALUE +/-push buttons.
F9 Bend DCA: This assigns the timbre amplitude control to the Pitch Bend Wheel, the intensity of which is estab-
lished by the value that can be modified using the VALUE +/-push buttons.
98
SD1 Owner's Manual