One Touch - KETRON SD1 User Manual

PROCEED AS FOLLOWS TO LOAD A SINGLE PROGRAM FROM DISK, WITH MASTER FOLDER ENABLED
Press the DISK push button.
Select the hard disk using the PAGE +/- push buttons.
Select the type of file to be loaded using F5 Folder Choice.
Select F2 Program.
Select the Program using the VALUE +/- push buttons.
Press F2 Load.

ONE TOUCH

As default setting the SD1 already contains a list of Voices put in order used to call up the timbres using the One Touch function. It is used to
create groups of ten Voices at a time with the preferred timbres to therefore speed up their access. To call up one of these timbres simply press
the 1 TOUCH push buttons (LED lit). On the main page the first ten Voices of the list are disdplayed. To display the other seven pages of ten
Voices each, use the first eight VOICES push buttons or scroll the pages using the PAGE +/- push buttons. To select the Voice desired press the
relative function push button. To modify the list proceed as follows:
Press the SAVE/ENTER push button:
Select F4 One Touch Edit which will display the first page of the list. To access the other pages use just the PAGE +/- push buttons.
Find the location to be replaced with a new Voice, selecting it using the function push buttons.
Select the Voice that will replace that in the list by following the procedures already described for calling up timbres. The audio files could
also be used but these will not be loaded automatically when turning on again. Furthermore, the SD1 does not acknowledge original audio
files within the list, which distributes the audio files in their loading order. If the audio files are to be used in One Touch it is advisable to
create a group of files to be loaded when starting up in the same order in which they appear in the list (Sound Block).
Press EXIT or wait a few seconds to return to the One Touch Edit page.
Once the list has been completed press SAVE/ENTER again.
Confirm the procedure using F10 Save or
Reset the original conditions of the list using F4 Undo or
Cancel the procedure using F5 Escape or
Reset the default list using F9 Default.
32
SD1 Owner's Manual