The Midi Parametes Of The Unit's Sections; Modifying A Parameter For The Sixteen Gm Parts; The Midi Set-Up's; The Parameters Of The Midi Menu - KETRON SD1 User Manual

MODIFYING A PARAMETER FOR THE SIXTEEN GM PARTS

As already mentioned the status of a single parameter for all sixteen tracks can be displayed using the F10 16 Parts function. To rapidly access
a parameter, select it from the GM Part page and then press F10 16 Parts to display the status of that parameter for the sixteen tracks. The
page F10 16 Parts structure shows a table with four lines and four columns relative to the sixteen Parts. To access the single Part use push
buttons F1 and F6 for Parts 1, 2, 3 and 4 that are selected by pressing the same push buttons repeatedly. Use push buttons F2 and F7 for Parts
5, 6, 7, and 8. Use push buttons F3 and F8 for Parts 9, 10, 11 and 12 and push buttons F4 and F9 for Parts 13, 14, 15 and 16. Once the Part has been
found its value can be modified using the VALUE+/- push buttons which, if pressed together at the same time, will reset the value.
The parameters that can be modified in this way are distributed over seven pages that are called up using push buttons PAGE +/-, and include
Volume, Reverb, Effects, Pan, Shift, Channel Rx, Channel Tx, already explained in the previous section.
The F5 Mute (Solo) function is used to establish which is the F10 Mute action. When F5 is set on Mute (Solo), F10 is used to cut-out only the
track selected at the time from the reproduction. Press F5 again and the relative function is changed into Solo (Mute) and F10 Mute cuts-
out all the tracks with the exception of that selected.
THE MIDI PARAMETERS OF THE SD1 SECTIONS
From the main page of the display press F6 MIDI to call up the menus dedicated to the SD1 sections. For each single function the single sec-
tions involved are displayed together with relative value. To move around between the sections use the CURSOR +/- push buttons and use the
VALUE +/- push buttons to modify the value.

THE MIDI SET-UP'S

To simplify programming the SD1 uses some memories called MIDI Set-up's that are used to save the settings of the MIDI receiving and trans-
mitting channels associated with the single sections and programmed in the Channel Transmit and Channel Receive menus. When a modifica-
tion has been completed in these menus, you can save it by pressing the SAVE/ENTER push button. The options available are the following:
F4 Undo: This returns to the page of MIDI channel settings, restoring the initial situation.
F5 Escape: This returns to the MIDI channel settings page without saving.
F9 Default: This restores the default settings.
F10 Save: This confirms that the settings in the current MIDI set-up are to be saved.
The preferred MIDI set-up can be called up when turning the instrument on using the Power On Setup function. Once the MIDI set-up has been
selected go back to the initial page of the MIDI menu using F5 Escape, press the SAVE/ENTER push button, select F3 Power On Setup and then
confirm using F10 Save. More details are given in the Power On Set-up section.

THE PARAMETERS OF THE MIDI MENU

107
Owner's Manual SD1