Programs And One Touch; Modifying A Program; A Guide To The Parameters - KETRON SD1 User Manual

Programs and One Touch

PROGRAMS
A number of timbres are often used simultaneously to enhance the timbre of the lead part, namely the right section to the right of the key-
board split point. The simplest method is that of using the Second Voice but for more demanding musicians up to four Voices combined togeth-
er differently can be exploited thanks to the 76-key keyboard. Using the Programs the musician can obtain a remarkably versatile timbre for
the right hand and also right along the keyboard. The player could, for example, use two further timbres for the Lower section and leave anoth-
er two for the Right section or use different timbres according to the key dynamics and again could transform the part of the keyboard to the
left of the split point into a real lower organ keyboard to be controlled with a MIDI pedal. Using the Programs the player can create Harmony
effects such as Duet, Trio and Steel. The SD1 provides the musician with 128 Programs that are distributed over sixteen pages of eight Programs
each. To call up a Program simply enable the PROGRAM push button and select one of the Programs displayed using the function push but-
tons. Use the sixteen VOICES push buttons to call up the groups of Programs.

MODIFYING A PROGRAM

Select a Program and then press the function push button relative to the Program selected again or from the main display, after having select-
ed the Program to be modified, access menu F8 Edit Program. In any event the display shows four columns, each of which corresponds to a
Voice used in the Program, whereas the horizontal lines refer to the parameters, grouped together in three pages that are accessed using the
PAGE +/- push buttons. To move around within the parameters of the horizontal lines use the corresponding function push buttons that select
the parameter at the side of that in use each time the push button is pressed again.

A GUIDE TO THE PARAMETERS

PAGE 1
From this page access is gained to some overall parameters that directly affect the Voice performance.
F1/F6 Voice: this indicates the timbre used for the Voice selected. To change it follow the exact same procedures used to call up a Voice
from the main page. The Preset voices, the User Voice and also the sounds of the RAM/Flash bank loaded in RAM can be used.
Once a Voice has been selected, wait a few seconds to return to the Edit Program page or press the EXIT push button. To
disable a Voice selected press the VALUE +/- push buttons together at the same time.
When a Voice is selected the F10 Harmony function appears immediately at the bottom right part of the display, which is
used to enable the harmonization function for that Voice. Only one Voice within the Program can use the harmonization
28
SD1 Owner's Manual