Automatic Vocal Set Loading On The Unit Power On; Vocal Set And Registration - KETRON SD1 User Manual

Use PAGE +/- to select the disk containing the file to be loaded .
Deactivate the MASTER FOLDER button, if this is active.
Select the type of files to be loaded pressing F5 File Choice; a number of different options appear next to the function buttons.
Select F7 Sound & Vocal as a file to be loaded.
If a number of files is displayed, select the desired one pressing the CURSOR +/- buttons.
Confirm the loading procedure pressing F2 Load.
Press EXIT twice to go back to the main page.
AUTOMATIC VOCAL SET LOADING ON SD1 POWER ON
Thanks to the Power On Setup function described in the special section, you may load the desired Vocal set on turning the SD1 on.
For this purpose, proceed as follows:
Access the On Line Effect menu pressing the relevant push button.
Use the F9 function key and the VALUE +/- push buttons to select the Vocal Set to be loaded on power up.
Exit the On Line Effect menu pressing the EXIT push button to return to the main page of the display.
Start the saving procedure pressing the SAVE/ENTER push button.
Confirm that you wish to save the current Vocal Set setting in the Power On Setup memory pressing the F3 function key.
On the display the following four options appear:
F5 Escape cancels the operation.
F8 Disk Save carries out the saving operation of the Power On Setup file with .PON extension either on the floppy disk or on the
hard disk, to be selected with the PAGE +/- buttons. If Master Folder is active, this file will be saved in the Userfile folder. If Master
Folder is disabled, the .PON file will be saved in the folder selected last.
F9 Default stores the Vocal Set as the one that will be called up on turning the SD1 on.
F10 Save writes in the Power On Setup memory in the Flash RAM.

VOCAL SET AND REGISTRATION

Each registration can store the Vocal Set to use, such as to drastically reduce the time required to select the parameters. On the other hand, it
might be useful not to load the Vocal Set assigned to the registrations if you wish to use a personalised setting without needing to modify all
the registrations. If you wish to avoid that a Vocal Set stored in the registrations is called up, proceed as follows:
On the first page of the display press F3 Utility.
Use the PAGE + button to go to the second page in the Utility menu.
Press F3 Registration Mode to display the single parameters.
From this page press F4 Effects to display how the single parameters will be managed.
Using the CURSOR +/- buttons select Vocalize and press F10 Select to disable the loading of the Vocal Set stored in a Registration. Set the
value to Off.
Press F7 Save to store the settings.
From this moment on when calling up a registration, the relevant Vocal Set will not be automatically loaded. To restore the selection of the Vocal
Set, repeat the procedure just described setting the value to On and then pressing F7 Save.
89
Owner's Manual SD1