Canon CP660 Service Manual page 85

4) Lift the upper cover, and disconnect
the connector; then, detach the upper
cover.
q w
q Upper cover
Figure 3-507
:
Caution
Put the connector w under the edge
saddle of the printer unit when mount-
ing the upper cover.
:
Caution
When mounting the upper cover to the
printer unit, check to make sure that
the two claws q of the upper cover are
fitted in the delivery assembly cover.
COPYRIGHT © 1999 CANON INC.
Download free service manual at http://printer1.blogspot.com
w Connector
q
CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 3 LASER EXPOSURE SYSTEM
4. Side Cover
1) If the PS/PCL board is installed,
loosen and remove the screws.
2) Open the left cover.
3) Remove the strap and the four
screws.
e
q
q Strap
e Side cover
Figure 3-508
4) Remove the seven screws, and
detach the side cover.
q
q Screws
Figure 3-509
w
w Screws
w
w Side cover
3-15