Canon CP660 Service Manual page 245

2. Removing the Heat Discharge Fan
(FM2; printer unit)
1) Perform the steps on p. 3-16 to
remove the rear cover.
2) Disconnect the connector, and disen-
gage the two claws; then, detach the
heat discharge fan 2.
q Connector
e Heat discharge fan 2
Figure 7-405
:
Caution
When mounting the heat discharge
fan, be sure that the logo of the manu-
facturer is toward the outside of the
printer unit.
3. Removing the Heat Discharge Fan
(FM3; printer unit)
1) Perform steps 1) through 5) on p. 3-18
to remove the right cover together with
the fan duct.
COPYRIGHT © 1999 CANON INC.
Download free service manual at http://printer1.blogspot.com
e
q
w
w Claw
CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
2) Disengage the two claws, and detach
the duct cover.
q
q Claws
Figure 7-406
3) Slide the heat discharge fan 3 by slid-
ing it upward.
q
q Heat discharge fan 3
Figure 7-407
:
Caution
When mounting the heat discharge
fan, be sure that the logo of the manu-
facturer is toward the outside of the
printer unit.
w
w Duct cover
7-11