Canon CP660 Service Manual page 144

CHAPTER 4 IMAGE FORMATION SYSTEM
3) While holding the left and right levers
of the intermediate transfer drum, pull
the drum straight; when it stops,
remove it as if to lift it at an angle.
Figure 4-824
Note:
The intermediate transfer drum is
heaviest at the rear. Remove it as if to
lift its rear.
2. Mounting a
Transfer Drum
1) Remove the protective sheet from the
new intermediate transfer drum as
shown.
Figure 4-825
4-46
COPYRIGHT © 1999 CANON INC.
Download free service manual at http://printer1.blogspot.com
New Immediate
Note:
Take care not to scratch the surface of
the intermediate transfer drum. Avoid
touching it.
2) Mount the intermediate transfer drum
by reversing the steps used to remove
it.
Figure 4-826
3) Shift back the bottom releasing lever
of the front cover to close the cover.
Note:
The intermediate transfer drum must
be mounted correctly to set the bottom
releasing lever.
4) Close the right cover and the front
cover.
CANON 660/2100 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)