Installing Sfp And Sfp+ Modules; Figure 27: Removing The Dust Plug From An Sfp+ Slot - Allied Telesis AT-x510-28GPX Installation Manual

Chapter 4: Cabling the Networking Ports
Installing SFP
and SFP+
Modules
70
To install SFP and SFP+ transceivers in slots 27 and 28 of the 28-port
switches and slots 51 and 52 of the 52-port switches, perform the following
procedure:
1. Remove the dust plug from a transceiver slot on the switch. Refer to
Figure 27.
Figure 27. Removing the Dust Plug from an SFP+ Slot
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. If you are installing the transceiver in a top slot, position the
transceiver with the Allied Telesis label facing up. If you are installing
the transceiver in a bottom slot, position the transceiver with the label
facing down.
4. Slide the transceiver into the slot until it clicks into place, as shown in
Figure 28 on page 71.