Figure 14: Switch Id Led - Allied Telesis AT-x510-28GPX Installation Manual

Chapter 1: Overview
42
The switch is booting up.
The switch has encountered a fault condition.
The switch is operating as a stand-alone unit, with the ID
number 0.
The switch has an ID number of 1 to 4 as part of a VCStack.
The dot in the lower right corner flashes when the switch
accesses USB memory.
The switch displays the letter "F" for fault on the ID LED if it encounters
one of the following problems:
A cooling fan has failed.

One of the power supplies has failed.

The internal temperature of the switch has exceeded the normal

operating range and the switch may shut down.
Note
You can use the SHOW SYSTEM ENVIRONMENT command in the
command line interface to identify the source of the problem.
The states of the LED when the switch is operating in the low power mode
are shown in Figure 15 on page 43.
Figure 14. Switch ID LED