Figure 30: Positioning The Sfp Or Sfp+ Handle In The Upright Position; Figure 31: Connecting A Fiber Optic Cable To An Sfp Or Sfp+ Transceiver - Allied Telesis AT-x510-28GPX Installation Manual

Chapter 4: Cabling the Networking Ports
72
6. Verify the position of the handle on the SFP transceiver. If the
transceiver is in a top slot, the handle should be in the upright position,
as shown in Figure 30. If the transceiver is in a bottom slot, the handle
should be in the down position.
Figure 30. Positioning the SFP or SFP+ Handle in the Upright Position
7. Connect the fiber optic cable to the transceiver, as shown in Figure 31.
The connector on the cable should fit snugly into the port, and the tab
should lock the connector into place.
Figure 31. Connecting a Fiber Optic Cable to an SFP or SFP+ Transceiver
8. Repeat this procedure to install additional transceivers.
SFP Handle